AnsweredAssumed Answered

Impossible to reset selections after apply dynamic selection using a procedure

Question asked by paolo.orlando on May 27, 2019
Latest reply on May 29, 2019 by Paul Wyatt - Avison Young UK

Hi to all,

I have a problem regarding a procedure.

 

In a screen I have created a label linked to a procedure that apply a dynamic selection on an entity.
The selection run perfectly (to check this I have a label that shown the current selections).
Unfortunately when I run the procedure clicking on the label, I cannot reset the selections made before in all selectors that there are in the screen.

 

The procedure has three steps:
1 - Selection
2 - Apply selection to screen
3 - Refresh screen

 

Board 10.3.0.51220

 

I need some help. Thank.

 

Paolo

Outcomes