NEXEL writeback not working

Alex Lanaro
Alex Lanaro
Second Anniversary
edited April 2020 in Platform
MAXIMUM URGENCY

Hi everyone,

I have a problem concerning the Nexel writeback.

As you can see from the picture attached (which is the Nexel layout shown in the debugger), the procedure enters the writeback with the proper selection, therefore the layout is not too big.
It writes correctly on the target cube but then, after the procedure finishes, only one of the two items is written.

If then I run the procedure, with just one item selected (the one which was previously empty), it works, but it doesn't seem to work with more than one item.

Does someone have some information about it?

Thanks in advance,
Alex
image


------------------------------
Alex Lanaro
Business Analyst
SDG CONSULTING ITALIA SPA
Italy
------------------------------
Tagged:

Answers

  • Domenico Panetta
    Domenico Panetta Employee
    Fourth Anniversary 25 Up Votes 10 Comments 25 Likes
    edited April 2020
    Hello Alex,
    could you show the Nexel formula and its type (if it is Single Formula or Deepest Entity)?

    Thank you

    ------------------------------
    Domenico Panetta
    Team Leader
    Board Community
    Italy
    ------------------------------
    -------------------------------------------

Categories