204 functional test

Auguste · 2024-08-16T15:49:11+00:00

There was an error rendering this rich post.

Auguste

Hello,

What could be the reason behind me not being able to see TOTAL values?

Find more posts tagged with

Accepted answers

Zayaan Wasif

Hi Auguste,

Would you be able to click on data block A itself (clicking on 'TEMP - ACT - DR - Units' in the screenshot you've provided above). That should open up the block settings panel to the right instead, it will look like this :

Is the 'Row Totals' enabled for that specific block?

All comments

Adrien Albrespit

Hi Auguste,

Can you please double check the following configurations of your dataview:

Axis settings: By Row: show all = no, down totals = yes // By Column: show all = no
Data > Set up: cube type = double, dimensions = month, store, product, Material and SalesPerson
Data > data block a: row totals = yes

According to your screenshot, everything else seems already OK.

Best Regards,

Adrien Albrespit

Zayaan Wasif

Hi Auguste,

As Adrien mentioned, please check if the data block settings match up with what Adrien has shared - specifically the row totals being enabled for that particular data block. For more information on all of the data block settings you can modify (including enabling row totals), please refer to this section of the Board Manual as it goes into each available setting in more detail:

https://help.board.com/v14/docs/about-data-block-settings#main-options

Thanks!

Auguste

Hi Adrien,

Thank you for your reply.

Not sure where to look for points 2 and 3:

Also, looking at the example screen it looks like for some reason I have less information on the right side (please see the example below):

Zayaan Wasif

Hi Auguste,

Is the 'Row Totals' enabled for that specific block?

Auguste

Hi Zayyan,

Thank you for your reply.

I redid everything and now it seems to be working but all the values are 4x… I saw people before faced a similar problem but it was 2x so will try to look at those threads.