Use Procedure to dynamic select value for LAYOUT

Harry Sun · 2024-09-28T23:46:42+00:00

There was an error rendering this rich post.

Harry Sun

Hi BOARD Team,

I understand we can use procedure to achieve dynamic selection for Data Block reference.

Can I do the same to make a selection to LAYOUT? Thanks

Find more posts tagged with

Procedures

Screen Design

Selection

Accepted answers

Jui Date

Hi Harry Sun,

If user wants to apply dynamic selection to one of the many layouts in the screen - There is procedural step of "Apply selection to Block" which will let user select the screen, layout and cube in the layout. So the user will have to carry out dynamic selection and then in the next step apply to the block in particular layout. Please note, if there are multiple layouts in the screen, user must name all these layouts. This will help user to choose correct layout while implementing this step.

2. If user wants to apply dynamic selection to all the layouts in the screen - After carrying out dynamic selection, select the option 'Apply selection to screen'

Hope this helps.

Regards,

Jui Date

All comments

Jui Date

Hi Harry Sun,

If user wants to apply dynamic selection to one of the many layouts in the screen - There is procedural step of "Apply selection to Block" which will let user select the screen, layout and cube in the layout. So the user will have to carry out dynamic selection and then in the next step apply to the block in particular layout. Please note, if there are multiple layouts in the screen, user must name all these layouts. This will help user to choose correct layout while implementing this step.

2. If user wants to apply dynamic selection to all the layouts in the screen - After carrying out dynamic selection, select the option 'Apply selection to screen'

Hope this helps.

Regards,

Jui Date