Level 300, Module 305, Product and Driver Mapping Data View Object Dataview Setup

Francisco Castillo Munoz

Hi, I'm stuck on module 305, trying to set up the Dataview in 'Driver and Source Mapping' screen. I'm following the steps, but my Dataview is completely different from the screenshot. Could you please help me figure out why?

This is how It look like on the module.

And this is how I have it on my side

If you notice in the preview I am no getting the same results.

Thanks for your help!

Marcus Smith

Hi @Francisco Castillo Munoz,

Hope you're doing well!

Concerning the data that is not appearing in the concerned Dataview, I would suggest performing some basic checks that can possibly solve the issue if the pain points are identified.

1. Ensure that the Cube - "PLN - Product and Driver Mapping" is configured and structured as below and the cube contains the required data by checking its size:
   "Group" should be "New Product Planning".
   "Data Type" should be "Single".
   "STRUCTURE" should include "Product" and "Driver".
2. Ensure that the "MAP - Product and Driver" Data reader and the "H – Product" Data reader is properly configured based on the Module.
3. Ensure you run these 2 data readers only if correctly configured.
4. Ensure the "Product and Driver Mapping" Data View Object is properly configured same as mentioned in the Module.

I would suggest expanding and referring to the steps listed in the collapsed Steps that can be found after every creation part in the module.

Additionally, please check if the default screen selections are not objecting to the values to appear in the reports.

Let me know if this is found to be helpful.