Hello everybody,
I am looking for a solution for arranging of the primary y axis.
I have these two bar diagrams:
My colleagues wish that both diagrams start with 0 and ideally use the entire width of the diagram.
For the right one it works with Autorange. It starts with 0 and automatically sets an plausible upper limit.
If I choose Autorange for the left diagram, the lower limit starts with 8000.
I compared all settings of the two diagrams but have not yet found a way to use autorange with a set mimimum of 0.
We are used Board 12.6.
Has someone else had this problem?
Thank you and best regards Simon
