Article How to loop procedures

Maik Burghardt

Hi, Just reading through the article : How to loop procedures

One part says

• Loading the extracted sequence into the Enumerator Cube so it looks something like this:

How do I load data into a Temporary cube? Via the Data Reader I cannot see them.

Thank you Maik

Edward

You should be able to add a temporary cube as a block in your data reader, in said block you then need to type in the exact cube name as the temporary cube that sits in your procedure.

See temp cube under more in the data reader example.

As a sidenote I can't remember which version it was added but I believe temporary cubes in data reader was introduced in one of the more recent Board 12 releases, maybe 12.5 or 12.6. (I could be misremembering this fact though).