Apply selection to screen not working

Catalina

Hello,

I have a procedure that allows me to go on a specific screen and apply the current selection. I use the steps below after "Go to screen"

Despite these the dataview are not updated though the selection are stored in memory.

This is what it displays when the screen opens (normaly I have only one selecion on unique ID on the first grid):

When I refresh the screen with the button at the top right, the selection applies correctly:

Thank you,

Catalina

Robert Barkaway

Hi Catalina, as logical as your method is you might have more success if you put the Apply Selection to Screen step before you navigate to the new screen, and then when you navigate to the screen do so with Keep Selection ticked, alternatively rather than setting the selection in the navigation procedure try putting it in a Screen Trigger on the screen, either of those should then avoid the issue you're seeing. I've had similar problems in the past and using one of the two methods I've suggested should work much better.