loading problem occurring after screen creation

REOUMBOULIANI

Hello, I'm currently training on module B14 Level 200 Part 2 - Building a planning solution in Board. I'm asked to build this screen

I followed the procedure, but I'm not getting any data.

I have checks:

But I can't figure out where the problem is coming from. Do you have any suggestions, please? Thank you in advance.

Marcus Smith

Hi @REOUMBOULIANI,

To solve the issue,

1. Check the cubes size - TEMP ACT DR UNITS. If this cube size is zero then no data will appear in the dataview.
2. Check the data reader if the cube is associated with the correct field.
3. Check the dataflow procedure is prperly configured which populates the data in the cube directly.

I hope this helps you.