Not all selections from BEx query appear in SAP Connector Designer
Hello,
while using the SAP connector designer, i have noticed some selctions from BEx queries do not show in the Connector Designer.
Even going through OnlineHelp - Theobald Software GmbH I don’t find explanation or mention about this.
Please find a screenshot attached where i show all BEx query selection in the Connector Designer. The missing one is highlighted.
Thanks in advance,
Regards
Accepted Answer
-
Hi
Only BEx variables that are defined in the "Filter - Characteristic Restrictions" area of the BEx query will be exposed in BW Extractor.
BEx variables defined in the "Default Values" area will not be exposed (as they are not supported by SAP's MDX OLAP BAPI interface).
So, check if the missing variables are defined in the Default Values section of the BEx query.4
Categories
- All Categories
- 1.8K Forums
- 1.7K Platform
- 105 Academy
- 280 Resources
- 3 Community Captains
- 1 About Community Captains
- 1 Meet the Community Captains
- 1 Topics & Thought Starters
- Board Manual
- 50 Best Practices
- 41 How-To Guides
- 25 Board Advocacy Program
- 157 Blog
- 4 Groups Hub
- 4 About Groups
- New Community Members
- DACH
- Japan
- Academy
- 2 Board Academy
- 7 ILT/VILT Course Catalogue
- 13 e-Learning Course Catalogue
- 4 Academy Forum
- 1.1K Idea Exchange
- 305 Partner Hub
- 2 Solution Sales Toolkits
- 91 Support
- 14 FAQ's
- Customer Support Portal
- 54 Support Articles
- BEAP