Call procedure doesn't work inside of a procedure

unknown

Hello,

I have a procedure "Initial launch" to execute initial data load. There are also some procedures inside this "initial launch" and some of them doesn't work. According to the log, the proceudre are launch but the output show that the different lines in the procedure didn't not work, dataflow in particular. Then if I run the affected procedures manually they work fine.

Any ideas about how to fix this issue.

Thank you and best regards

Marcel

Daniel Zillmann

Hi Marcel,

 

The only thing that I can think off is that the procedures might been renamed in the past. In that case you should delete the launch procedure step and recreate it. I have never experienced any other issues than that one.

 

Cheers,

Daniel