Why is the data not populating on my Data View?
Hello,
Thank you for contacting Board product support. My name is Gavin Murray.
To identify the issue better, I request you to help us with the below-mentioned information:
For eg. 209: Expense Planning Upload >> Build actual expense data >> Lesson/Activity Name
We look forward to your response.
Regards,
Gavin Murray
Hey Gavin,
Thanks for the response, I am doing Level:304 - Planning Expansion New product based on drivers. Here are the steps and the image
Add a Data View object onto the Screen.
In "CONFIGURE LAYOUT", use the "PLN - Product and Driver Mapping" Cube as data block "a".
Set the "BY ROW" axis to "Product" first, then "Driver" second.
In "DATA VIEW SETTINGS", set the "COLUMN APPEARANCE" of data block "a" to "Checkbox". Select "APPLY".
In "AXIS SETTINGS", remove the selection on "Down totals" and select "APPLY" and "SAVE".
Thank you for your response. I appreciate your efforts in sharing the requested information along with the screenshot.
Based on the screenshot, I can confirm that you are currently on Module 305: Planning Expansion – New-Product Planning Based on Drivers, specifically at Step 7: Add New Products for Driver-Based Planning.
From what you’ve shared, it appears that you have successfully completed Module 304 and progressed through the first six steps of 305. Could you please confirm if you were able to achieve the expected results for all the previous steps as outlined in the course?
It seems that everything was working correctly until you reached the 'Product and Driver Mapping' Data View Object in Step 7, and this is where the issue began. Please confirm if this understanding is correct.
To help us investigate further, kindly share the following:
Once we have this information, we’ll be in a better position to support you.
Looking forward to your response.
Best regards,
The screenshot above matches the step I am in; you are correct.
Below are the screenshots you requested.