Apply to Block - not working / applied on drill down

Maik Burghardt

Hi,

I have a procedure that switches an entity selection on a chart which is working fine.

However, when I then use the drill down it doesn't pickup that selection.

Any idea how to fix this? Or have a different approach?

Thanks Maik

Find more posts tagged with

Configure

User Experience

Board 14

Accepted answers

Björn Reuber

Hello,
the challange is, that there might be different drill layout, so it is more like a philosophical question.

Which part of the Layout shall be overwritten and which not, as in the stored drill layout you might have other cubes, etc

All comments

Björn Reuber

Hello Maik,

I assume you are using the drill, which is pre-defined by the administrator (i assume there is a certain drill layout). Can you please try, if it is working on an drill anywhere

regards

Björn

Maik Burghardt

Jesus :)

I would have expected that the system is adjusting anyway.

With drill anywhere - You then loose the entire drill down setup.

That behavior doesn't make sense to me. I assume the only fix is to screen additional screens two show the different selections?

Björn Reuber

Hello,
the challange is, that there might be different drill layout, so it is more like a philosophical question.

Which part of the Layout shall be overwritten and which not, as in the stored drill layout you might have other cubes, etc