Dataview not able to drill

Previous Member
Previous Member
500 Up Votes 500 Likes 500 Comments Second Anniversary
edited April 2020 in Platform

Hey guys,

 

if I want to drill down in one of my dataviews and it shows me the following error, what could be the cause? 

 

image

Answers

  • Alexander Kappes
    Alexander Kappes Employee
    Fourth Anniversary 250 Likes 100 Comments 5 Answers

    Dear Antoni Theodorou,

     

    thanks for your request.

     

    The Message Box can be due to several reasons.

     

    1. Does the message occur for each or just for special lines in your DataView?

    2  Does it occur for each drilled entity or just for special ones?

    3. What is the detailized Configuration of your Layout, did you try to reconfigure another DataView and check starting from what point the problem occurs?

    4. Did you check the relationships, when you build up the axis depending to your drill, will the layout be executed?

     

    Thanks for some additional information

     

    regards

     

    Alexander Kappes

  • Previous Member
    Previous Member
    500 Up Votes 500 Likes 500 Comments Second Anniversary

    Hey Alexander Kappes

     

    1. The message occurs for each line in this dataview.

    2. It occurs for one entity i need to show (projects)

    3. I will test it today to rebuild the dataview step by step

    4. Normally the relationships etc must be fine because i use other dataviews with the same drill and there is no problem.

     

    Thank you for your help I will try to rebuild the dataview and report again.

     

    regards 

     

    Antoni Theodorou

Categories