(FIXED) Capsule Procedure Issue - GETBACK

Paul Wyatt
Paul Wyatt Customer
100 Comments 100 Up Votes 100 Likes Second Anniversary
edited April 2020 in Platform

Has anyone experienced issues with their capsule procedures in v10.5?  I cannot get any capsule procedure to function that uses GETBACK.  Instead, I get a constantly refreshing screen loop which is difficult to break out of without closing the browser (Chrome).

 

By removing the getback, the procedure performs as it should.  However, I cannot practically re-write every capsule procedure.  Converting to 10.5 is proving to be quite a challenge.  Is anyone aware of this issue in v11?  

 

Image 1: The procedure containing a GETBACK instruction

 

(Deleted)

 

Image 2: The outcome when performing the capsule procedure above: 

 

image

Answers

  • Graeme Whorrall
    Graeme Whorrall Active Partner
    Fourth Anniversary 10 Comments Board Developer Level 200: Building A Planning Solution in Board

    Hi Paul,

     

    Maybe try adding an Exit procedure at the end, not sure why the GETback is causing this issue for you though?

     

    Regards

     

    Graeme

  • Paul Wyatt
    Paul Wyatt Customer
    100 Comments 100 Up Votes 100 Likes Second Anniversary

    Thanks Graeme for the reply.  It is possible that there were capsule migration issues causing this issue as it does not appear to be present in v11.  As I have decided to migrate from 10.1.4 to 11, I am now dropping this issue.  

     

    However, if anyone else experiences it and resolved the problem, I would still be interested to learn more,

  • Paul Wyatt
    Paul Wyatt Customer
    100 Comments 100 Up Votes 100 Likes Second Anniversary

    I'm considering this fixed as there are so many factors in migrating from B10.1.4 to B10.5 it could be anything and not really fair to post a problem that may well be localised to a few users in esoteric situations.

  • Previous Member
    Previous Member
    500 Up Votes 500 Likes 500 Comments Second Anniversary

    In the release notes for the latest 10.5 it says:

    "- A malfunction on Go to Group and interactive selection that leads to loop in procedure, has been fixed"

     

    This might solve your problem.

     

    BR

    Mark

Categories