Corporate Company Designer - Configure blocks width

Annika Fava
Annika Fava Customer
Third Anniversary First Comment 5 Likes
in Platform

Hello,

 

I'm trying to save a new standard for the blocks with of a data view in the corporate company designer.

I save my setting and close. But when I open it again the standard setting of 120 is back again.

 

And the main problem is when I drill into a dataview this blocks width is always there even if a saved another width in my data view. This makes the drilling very uncomfortable.

 

(We have 10.1 at the moment.)

 

KR

Annika

Answers

  • Alexander Kappes
    Alexander Kappes Employee
    Fourth Anniversary 250 Likes 100 Comments 5 Answers

    Dear Annika Fava,

     

    thanks for your request.

     

    Unfortunately it is not possible to save the block width by default. To be honest it don´t make any sense doing this, because you don´t know how many blocks your layout consists.

     

    Concerning your Dril Case, normally when you change the Drill Layout itself it is saved. I know that you only can resize the columns by using the mouse but never the less your settings should been saved inside your capsule. The same, when you use other Blocks for the drill or something similar.

     

    Hope it helps

     

    regards

     

    Alexander Kappes

Categories