About the steps marked "Call procedure" in the procedure

I thought that I had reconfigured the target procedure, but for some reason the settings were not reflected as shown in ①-⑤ below.
I selected a completely different procedure once in ②, saved it, and then selected the desired procedure again and saved it, and the setting was reflected and the step that calls the procedure moved.
We were able to solve the problem.
Thank you so much.

①Before Modification

②Reselect the procedure and press the save button

③After making changes, press the save button at the bottom right

（The correct procedure for the purpose has been reselected）

④With the correct procedure reselected, enter edit mode again

⑤It should have been reconfigured, but the procedure before the configuration is specified

All comments

Dominique Duchenne

Hi Msgiyama,

Is it possible for you to share how the procedures have been configured?

Some screen shots would be great so we can understand a little more.

Thank you

Dominique

Samir Jones

@MSugiyama, have you changed name on the target procedure?

Go to the Call Procedure step and make a temporary change, and then change back to the correct target procedure, so that you can save it again.

Unfortunately, the names in the Call Procedure step are not dynamic.

MSugiyama

@Dominique Duchenne

Hello.

I have attached below a screenshot of the procedure I created.

I have my language set to Japanese, so I apologize if the information is difficult to understand.

[The calling procedure]

Step 26 calls another procedure

[The procedure I want to call]

MSugiyama

@Samir Jones

Hello.

I checked the "Call Procedure step" and the desired procedure and database were set as shown in the attached image. Should I reselect the same items and save?
Thank you.